3D printer supercar

Discussion in 'SRT Hellcat General Discussions' started by F6F, Jul 15, 2015.

  1. F6F

    F6F BANNED

    Joined:
    Dec 19, 2014
    Messages:
    2,089
    Likes Received:
    1,014
    Trophy Points:
    668
    Location:
    Team Hellcat, MD
    Vehicle:
    Challenger SRT Hellcat
    I was browsing the internet and found this

    Kevin Czinger s Ideal Sports Car Just Emerged From A 3-D Printer

    I sent an email inquiring about the car and also asked if they can make a Challenger Hellcat chassis with their system. To my surprise, Kevin Czinger answered my email (hopefully it wasn't John Dodge) and said that they can:

    Yes, but for right now we are focused on standardizing the manufacturing platform for licensing to other manufacturers and building and selling a limited series of the Blade.

    Kind regards,

    Kevin

    It is a 1400 pound car that goes from 0 to 60 in less than 2 seconds and it has a 700 HP engine. Amazing guys.

    I want that car now !!
     
  2. TIGwelder

    TIGwelder SSDD

    Joined:
    Feb 12, 2015
    Messages:
    2,437
    Likes Received:
    943
    Trophy Points:
    668
    Location:
    Cape Coral, SW Florida
    Vehicle:
    Challenger SRT Hellcat
    Sick

    Heck, just the engine cradle and cradle for rear diff/suspension on our cars would knock off a bunch of weight
     
  3. Supercharged_Fun

    Supercharged_Fun Silver Member

    Joined:
    Jun 25, 2015
    Messages:
    668
    Likes Received:
    199
    Trophy Points:
    153
    Vehicle:
    Challenger SRT Hellcat
    My boss showed me this the other day. Very impressive.
    We have 4 HP digital print presses at work. I told him we need to get a 3D printer next. LOL
    :D
     

Share This Page