Need help with rear wheel 20X10-18mm offset fitment confirmation

Discussion in 'SRT Hellcat Wheels and Tires' started by HCone, Jan 11, 2016.

  1. HCone

    HCone Gold Member

    Joined:
    Dec 4, 2014
    Messages:
    1,055
    Likes Received:
    303
    Trophy Points:
    218
    Location:
    upper center middle of no where
    Vehicle:
    Challenger SRT Hellcat
    I found a set of rear rims for my car, they are 20 X10 with 18mm offset ( Most 20X10's I have seen mounted here are 25mm offset)

    I would like to mount Mickey Thompson Street Comp 305/35-20 tires ( width 12.3 inches ) on them

    I think this should be OK for rear clearance, but can anyone please confirm for me, before I order them?

    Thanks for any help !!
     
  2. 1949chopper

    1949chopper NC STATE PRESIDENT Hellcat Car Club HCC Charter Member

    Joined:
    Oct 5, 2014
    Messages:
    1,254
    Likes Received:
    574
    Trophy Points:
    563
    Location:
    Gold Hill NC
    Vehicle:
    Challenger SRT Hellcat
    Chris Salter has them on his car that is for sale in the marketplace section. Ask him. Maybe he will sell you his
     
  3. HCone

    HCone Gold Member

    Joined:
    Dec 4, 2014
    Messages:
    1,055
    Likes Received:
    303
    Trophy Points:
    218
    Location:
    upper center middle of no where
    Vehicle:
    Challenger SRT Hellcat
    Thanks, but not the answer I am looking for
     
  4. 1949chopper

    1949chopper NC STATE PRESIDENT Hellcat Car Club HCC Charter Member

    Joined:
    Oct 5, 2014
    Messages:
    1,254
    Likes Received:
    574
    Trophy Points:
    563
    Location:
    Gold Hill NC
    Vehicle:
    Challenger SRT Hellcat
    So ASK HIM
     
  5. HCone

    HCone Gold Member

    Joined:
    Dec 4, 2014
    Messages:
    1,055
    Likes Received:
    303
    Trophy Points:
    218
    Location:
    upper center middle of no where
    Vehicle:
    Challenger SRT Hellcat
    The MT hyper silver come in 9 and 10.5 widths with 10 and 24 mm offsets.Not what I am looking for but,
    I HAVE SENT HIM A PM
     
  6. 1949chopper

    1949chopper NC STATE PRESIDENT Hellcat Car Club HCC Charter Member

    Joined:
    Oct 5, 2014
    Messages:
    1,254
    Likes Received:
    574
    Trophy Points:
    563
    Location:
    Gold Hill NC
    Vehicle:
    Challenger SRT Hellcat
    You have to do the math. I was gonna get the American racing torq thrust M in 20x 10 withb18 offset. The math works out to be an additional 1/4 inch on both sides which I think will clear. Someone on here has that exact setup. I'll see if I can find them
     
  7. HCone

    HCone Gold Member

    Joined:
    Dec 4, 2014
    Messages:
    1,055
    Likes Received:
    303
    Trophy Points:
    218
    Location:
    upper center middle of no where
    Vehicle:
    Challenger SRT Hellcat
    I did the math and pretty sure will be no issue, but before I drop 3K, just want to make sure
    I have done a search on a couple of forums, but have not found anything definitive yet,,,,still looking
    Thanks for any help !!
     
  8. 1949chopper

    1949chopper NC STATE PRESIDENT Hellcat Car Club HCC Charter Member

    Joined:
    Oct 5, 2014
    Messages:
    1,254
    Likes Received:
    574
    Trophy Points:
    563
    Location:
    Gold Hill NC
    Vehicle:
    Challenger SRT Hellcat
    That's why I didn't pull the trigger. Very expensive lesson if you miscalculate. Good luck.
     
  9. HCone

    HCone Gold Member

    Joined:
    Dec 4, 2014
    Messages:
    1,055
    Likes Received:
    303
    Trophy Points:
    218
    Location:
    upper center middle of no where
    Vehicle:
    Challenger SRT Hellcat
     
  10. HCone

    HCone Gold Member

    Joined:
    Dec 4, 2014
    Messages:
    1,055
    Likes Received:
    303
    Trophy Points:
    218
    Location:
    upper center middle of no where
    Vehicle:
    Challenger SRT Hellcat
    I may be your guineau pig
     
  11. DGatzby

    DGatzby Gold Member Hellcat Car Club HCC Charter Member Midwest Regional Pres.

    Joined:
    Jan 16, 2015
    Messages:
    2,895
    Likes Received:
    1,454
    Trophy Points:
    598
    Location:
    Twin Cities, MN
    Vehicle:
    Challenger SRT Hellcat
    That is the same as the stock backset 18 or 19mm. You are correct the 10" wheel will be in the same position but be 1/4" wider outside and inside. No rubbing issue. The 10-10.5" wheels that have the greater backset pull the tires in tighter obviously. Those 305's will work with a 25 mm backset FYI.
     
  12. Chris Salter

    Chris Salter Silver Member

    Joined:
    Jan 19, 2015
    Messages:
    145
    Likes Received:
    51
    Trophy Points:
    138
    Location:
    Louisiana
    Vehicle:
    Challenger SRT Hellcat
    I had no issues with the M/T Comps and I loved the look. The wheels seem to make the car look brighter and sportier.
     
  13. TrackDay

    TrackDay Silver Member

    Joined:
    Mar 28, 2015
    Messages:
    753
    Likes Received:
    203
    Trophy Points:
    153
    Location:
    Michigan
    Vehicle:
    Challenger SRT Hellcat
    One of the guys on here had Axis Model Two wheels on all fours with a sublime Scat Pack. They are 20x10 with a 20mm offset. He had 315/35 Nitto DRs on the rear IIRC. He posted them for sale in the fall. The fitment was really good based on the pictures and his comments.

    Found the pictures and one of his posts. There are multiple. 20x10 Axis Model 2 wheels all around
     
  14. nycAirSpeed

    nycAirSpeed Senior Hellcat Member

    Joined:
    Oct 9, 2015
    Messages:
    64
    Likes Received:
    36
    Trophy Points:
    58
    Vehicle:
    Challenger SRT Hellcat
    - 4k miles on Hurst Dazzler 20x10x18mm on all four - I've had absolutely zero problems... I believe these to be the widest rims you can get in front though, clearance is tight there. :rolleyes:
    20151124_163224.jpg
     
    • Like Like x 1
  15. HCone

    HCone Gold Member

    Joined:
    Dec 4, 2014
    Messages:
    1,055
    Likes Received:
    303
    Trophy Points:
    218
    Location:
    upper center middle of no where
    Vehicle:
    Challenger SRT Hellcat
    Thanks for the help guys, for better or worse, I ordered the rims today.
    Car is stored right now until May, but when I get installed I'll post pics
     

Share This Page

Search tags for this page

wheel offset challenger 20x10