Plastic panel under hood release.

Discussion in 'SRT Hellcat General Discussions' started by Chippy, May 23, 2015.

  1. Chippy

    Chippy Silver Member

    Joined:
    Nov 27, 2014
    Messages:
    587
    Likes Received:
    124
    Trophy Points:
    153
    Location:
    Alberta
    Vehicle:
    Challenger SRT Hellcat
    I'm going to mount my front facing camera today. Does the plastic panel with the drink holders come off easy?
    Thanks in advance I'd rather work top down rather than from the bottom up.
     
  2. Chippy

    Chippy Silver Member

    Joined:
    Nov 27, 2014
    Messages:
    587
    Likes Received:
    124
    Trophy Points:
    153
    Location:
    Alberta
    Vehicle:
    Challenger SRT Hellcat
    Never mind it came off very easy but running lines up there a pia. Every thing out to front grills are pretty much covered for air management. Not a lot of room to work on these cars for sure.
     
  3. Cruisin1966

    Cruisin1966 Silver Member

    Joined:
    Nov 8, 2014
    Messages:
    1,089
    Likes Received:
    232
    Trophy Points:
    198
    Location:
    Calgary
    Vehicle:
    Challenger SRT Hellcat
    Are ya done yet? Can I see?
     
  4. HCone

    HCone Gold Member

    Joined:
    Dec 4, 2014
    Messages:
    1,055
    Likes Received:
    303
    Trophy Points:
    218
    Location:
    upper center middle of no where
    Vehicle:
    Challenger SRT Hellcat
    I just mounted front parking sensors, talk about a PIA, looks good though

    [​IMG]
     
    • Agree Agree x 1

Share This Page