programming garage door opener

Discussion in 'Dodge Challenger SRT Hellcat' started by bighit2883, May 16, 2015.

  1. bighit2883

    bighit2883 Gold Member

    Joined:
    Mar 15, 2015
    Messages:
    1,141
    Likes Received:
    407
    Trophy Points:
    358
    Vehicle:
    Challenger SRT Hellcat
    Hey guys, quick question. How would i program my built in garage opener? My owners manuals are at my parents as my dad was reading up on them. Im sure its probably as simple as press button on lift...press button in car but just wanna make sure. Thanks
     
  2. 65 Stingray

    65 Stingray Rookie

    Joined:
    Mar 14, 2015
    Messages:
    21
    Likes Received:
    1
    Trophy Points:
    3
    Location:
    Finger Lakes, Upstate NY
    Vehicle:
    Challenger SRT Hellcat
    For a rolling code opener, place your garage doors remote close to the module/button you want to program inside the car, press both simultaneously, when the yellow light on the cars opener starts to flash fast, get out and press the button on the drive motor inside your garage, don't remember how it's labeled but its a programing button, once you do this, go back to the car and press the button you programmed twice. BTW, you need to have the car ignition on while doing this.
    If this fails, you can always find the owners manual online. Hope this helps (I believe this is the sequence I followed last weekend)
     

Share This Page

Search tags for this page

2015 challenger homelink programming

,

hellcat garage door

,

program 2014 challenger garage opener

,

program dodge challenger srt garage door opener

,

srt challenger srt garage door setup