Radio/AMP Pinouts

Discussion in 'SRT Hellcat Electronics' started by zippy, May 10, 2015.

  1. zippy

    zippy Silver Member

    Joined:
    Feb 2, 2015
    Messages:
    350
    Likes Received:
    124
    Trophy Points:
    193
    Location:
    Ontario
    Vehicle:
    Charger SRT Hellcat
    Hi Everyone


    I wanted to know if anyone had an HK system amp pinout.

    I am somewhat of an audiophile and want to add a couple x series alpine subs in the trunk to make up for the HK sub system (I will be diabling this). In actuality, the factory system is very clean sounding and just needs a boost on the bass side in my opinion

    Am going to tap the rear speaker wires (I assume they are full range) directly out of the amp under the dash and route in to my new 2000W rms Alpine amp as a high level speaker input.

    Any help on the pinout diagram(s) for the HK system would be appreciated.

    I was looking for a service manual online (which I would by but can't seem to find one

    Thank You

    Zip
     
  2. Snappycat

    Snappycat SRT Hellcat Moderator Staff Member

    Joined:
    Jan 22, 2015
    Messages:
    3,462
    Likes Received:
    1,033
    Trophy Points:
    628
    Location:
    The I.E. So. Cal
    Vehicle:
    Challenger SRT Hellcat
    I am also wondering if a bass dial can be added? I have one in my Tacoma and it is nice to be able to adjust the bass depending on the recording quality without having to mess with the EQ.
     
  3. fnkychkn

    fnkychkn swollen member Gold Supporting Member

    Joined:
    Jan 24, 2015
    Messages:
    1,371
    Likes Received:
    486
    Trophy Points:
    368
    Location:
    plastic take-out container
    Vehicle:
    Charger SRT Hellcat
    pm me last 8 of VIN for accuracy (VIN specific diagram/pinout).
     

Share This Page

Search tags for this page

increase power to hellcat h&k system