Thanks Razor's Edge

Discussion in 'SRT Hellcat General Discussions' started by HCone, Jun 19, 2015.

  1. HCone

    HCone Gold Member

    Joined:
    Dec 4, 2014
    Messages:
    1,055
    Likes Received:
    303
    Trophy Points:
    218
    Location:
    upper center middle of no where
    Vehicle:
    Challenger SRT Hellcat
    Just spoke to Paul at Razor's Edge and ordered subframe connectors, rear tension bars in red and front/rear strut/shock tower braces in red. He was extremely helpful !

    Let the mods continue...............
     
    • Like Like x 1
  2. Aaron Vogel

    Aaron Vogel Silver Member

    Joined:
    Jan 23, 2015
    Messages:
    1,263
    Likes Received:
    230
    Trophy Points:
    198
    Location:
    Everywhere
    Vehicle:
    Challenger SRT Hellcat
    All great products, i've been running the subframes since March, i liked them. I will be getting the front and rear strut braces when i get back as well
     
  3. HCone

    HCone Gold Member

    Joined:
    Dec 4, 2014
    Messages:
    1,055
    Likes Received:
    303
    Trophy Points:
    218
    Location:
    upper center middle of no where
    Vehicle:
    Challenger SRT Hellcat
    Any noticeable difference ?
     
  4. Aaron Vogel

    Aaron Vogel Silver Member

    Joined:
    Jan 23, 2015
    Messages:
    1,263
    Likes Received:
    230
    Trophy Points:
    198
    Location:
    Everywhere
    Vehicle:
    Challenger SRT Hellcat
    I noticed it a little bit with the subframes, they were bolt in, not weld in (just my preference) and i only had them in for a few weeks before i left, but it did feel a ittle better on the turns. But this Challenger feels much tighter/firmer from the factory then my 2010 did. I had all these same braces in my 2010 and it made a huge difference. So, can't wait to see how all 3 in this car feel also
     

Share This Page