Torque across the board

Discussion in 'SRT Hellcat Performance' started by Supercharged_Fun, Feb 13, 2016.

  1. Supercharged_Fun

    Supercharged_Fun Silver Member

    Joined:
    Jun 25, 2015
    Messages:
    667
    Likes Received:
    199
    Trophy Points:
    153
    Vehicle:
    Challenger SRT Hellcat
    Does anyone know mods/tune are used here, or was it just a tune? I find hard to believe it was just a tune. Maybe I'm wrong?? Either way, that is mighty impressive. The power and torque numbers are killer and look at the torque line. Insane. Car must pull like crazy.

     
    • Agree Agree x 1
  2. Supercharged_Fun

    Supercharged_Fun Silver Member

    Joined:
    Jun 25, 2015
    Messages:
    667
    Likes Received:
    199
    Trophy Points:
    153
    Vehicle:
    Challenger SRT Hellcat
    Does anyone know if Arrington Performance is a reputable shop? They seem reputable and look to have a nice facility.
    What they did to this Hellcat is great! Impressive numbers, especially with that torque line. Almost 700lbs. of torque at 3000RPM?!? And it doesn't drop off till after 6000 RPM. That's very impressive.
    Thanks!
     
    • Agree Agree x 1
    • Winner Winner x 1
  3. Mills

    Mills Silver Member

    Joined:
    Jan 28, 2015
    Messages:
    589
    Likes Received:
    133
    Trophy Points:
    153
    Location:
    Airdrie, Alberta
    Vehicle:
    Challenger SRT Hellcat
    Green belt - so I would say a pulley and tune
     
    • Like Like x 1
    • Agree Agree x 1
  4. Supercharged_Fun

    Supercharged_Fun Silver Member

    Joined:
    Jun 25, 2015
    Messages:
    667
    Likes Received:
    199
    Trophy Points:
    153
    Vehicle:
    Challenger SRT Hellcat
    I saw that too. I think I read in the comments that the only mods were an underdrive pulley and tune. If that is the case,..............that is AMAZING!! That torque level is insane.
     
  5. Mills

    Mills Silver Member

    Joined:
    Jan 28, 2015
    Messages:
    589
    Likes Received:
    133
    Trophy Points:
    153
    Location:
    Airdrie, Alberta
    Vehicle:
    Challenger SRT Hellcat
    There are a couple builds in the build section that are basically a pulley and tune - 2.75 and 2.85 metco units - you may wanna check those out if you think these are awesome ;)
     
    • Like Like x 1
  6. Supercharged_Fun

    Supercharged_Fun Silver Member

    Joined:
    Jun 25, 2015
    Messages:
    667
    Likes Received:
    199
    Trophy Points:
    153
    Vehicle:
    Challenger SRT Hellcat
    Thanks Mills. I have seen one or two. I need to catch up on some reading as I haven't been in the performance section much lately. Thanks man. I appreciate it.
     
  7. Teo

    Teo Judge Yooper

    Joined:
    Jun 7, 2015
    Messages:
    880
    Likes Received:
    441
    Trophy Points:
    313
    Location:
    Yooper Land
    Vehicle:
    Challenger SRT Hellcat

    TC & Linda are keeping ALL well informed with their info. What is Linda's receipe for a 9 sec Cat blower only?

    All work and tune done by HHP :)
     
    • Like Like x 1
  8. 1949chopper

    1949chopper NC STATE PRESIDENT Hellcat Car Club HCC Charter Member

    Joined:
    Oct 5, 2014
    Messages:
    1,254
    Likes Received:
    574
    Trophy Points:
    563
    Location:
    Gold Hill NC
    Vehicle:
    Challenger SRT Hellcat
    No they are not. I had one they built and it was in the shop 8 times in one year. Ultimately traded for a ram 3500. Lost my ass. Highly UNrecomend
     
    • Like Like x 1
    • Winner Winner x 1
  9. Supercharged_Fun

    Supercharged_Fun Silver Member

    Joined:
    Jun 25, 2015
    Messages:
    667
    Likes Received:
    199
    Trophy Points:
    153
    Vehicle:
    Challenger SRT Hellcat
    Wow,...that's horrible. Sorry about that.
    Thanks for your reply.
     

Share This Page