Verify amp flash completed?

Discussion in 'SRT Hellcat Electronics' started by Falkirk18, May 27, 2015.

  1. Falkirk18

    Falkirk18 Rookie

    Joined:
    Feb 19, 2015
    Messages:
    24
    Likes Received:
    6
    Trophy Points:
    3
    Vehicle:
    Charger SRT 392
    So, not to go into great detail, I'm concerned the dealer didn't actually complete the TSB for the HK amp flash.

    Is there a way to verify it was done? For example, can you look up the software/firmware version like you can for the uconnect software? After they gave me my car back and said the tech couldn't find anything wrong with the HK system and it didn't need any flash, I had a meltdown. Then they took it back after I had to speak with the service manager and provide him with the TSB.

    Thx for any help.
     
  2. Colorado Hellcat

    Colorado Hellcat Silver Member

    Joined:
    Nov 13, 2014
    Messages:
    536
    Likes Received:
    111
    Trophy Points:
    153
    Vehicle:
    Charger SRT Hellcat
    Just tune it to a good fm station. Turn the volume up to about 28. Go to the fader. Fade to full front. Gauge how it sounds. Then fade all the way to the back. If the front and back sound about the same then he did the flash. If the back sounds very week compared to the front then it was not done. By the way. Do you know when your build date? Was it before the clear date of the tsb?
     

Share This Page

Search tags for this page

how to turn the audio amp up on 2015 challenger

,

sotware flash for amp