What brand and part number headers and off road pipe u using??

Discussion in 'SRT Hellcat Performance' started by rollracing, Oct 27, 2015.

  1. rollracing

    rollracing Senior Hellcat Member

    Joined:
    Mar 15, 2015
    Messages:
    119
    Likes Received:
    26
    Trophy Points:
    58
    Location:
    Fredericksburg Indiana
    Vehicle:
    Challenger SRT Hellcat
    Just curious to know what everyone is using. ARH give me a certain number but it states its for srt 6.1-6.4 motors most 6.4 stuff is same for 6.2 hellcats but thought 6.1 stuff was totally different??? including thermostats ect..
    tell me pros and cons of =what u have and will it mate up to stock exhaust from mid to rear
     
  2. Aarcuda

    Aarcuda Gold Member

    Joined:
    Oct 22, 2014
    Messages:
    1,430
    Likes Received:
    461
    Trophy Points:
    258
    Location:
    The Boonies
    Vehicle:
    Challenger SRT Hellcat
    what size primary tubes are they?
     
  3. rollracing

    rollracing Senior Hellcat Member

    Joined:
    Mar 15, 2015
    Messages:
    119
    Likes Received:
    26
    Trophy Points:
    58
    Location:
    Fredericksburg Indiana
    Vehicle:
    Challenger SRT Hellcat
    That's what I am asking
    What do u have on ur cat??
     
  4. Aarcuda

    Aarcuda Gold Member

    Joined:
    Oct 22, 2014
    Messages:
    1,430
    Likes Received:
    461
    Trophy Points:
    258
    Location:
    The Boonies
    Vehicle:
    Challenger SRT Hellcat
    I have the stock manifolds on mine now. But I did have ARH 1 3/4" headers on my RT but sold them when I sold the car/ I might want a set for the hellcat but i know the 1 3/4" headers were too small. So that leaves 1 7/8" unless the hellcats need a bigger primary
     

Share This Page