SRT Hellcat Forum banner
  • Hey Everyone! Enter your ride HERE to be a part of this months Ride of the Month Challenge!
1 - 2 of 2 Posts

·
Registered
Challenger SRT Hellcat
Joined
·
14 Posts
Discussion Starter · #1 ·
I Purchased 18 X 5 Weld S71 wheels for the fronts on my 17 Hellcat. Part # 71HB8050W21A. Vendor said a 5mm spacer was needed to clear the calipers.
With the 5mm spacers, I still have clearence issues.
Anybody else run into this? I can get a thicker spacer, but will run into wheel stud length issues. Plus, I'm not too keen on running super thick spacers.

Thanks.
 

·
Registered
Challenger SRT Hellcat
Joined
·
2,004 Posts
Wow as much as you pay for those wheels you would think Weld would have made them so you didn't need spacers... I agree with you on thick spacers and the diminishing wheel studs is not ideal. I'm sure you'll have a good response here shortly.
 
  • Like
Reactions: OldMoparGuy
1 - 2 of 2 Posts
Top