[BSouders80]

What kind of 60' times are you running? What are you doing to get a decent 60' time?

I have McLeod 1200 clutch, carbon fiber ds, 1400 hp axle upgrade, rear diff brace and 17" wheels with 305/45/17 MT ET Street R's.
Stock trans for now.

Running E85 (Renegade E112) and put up 960 whp a few weeks ago.

I've yet to have a hard pull, but the few times I have ran it, I'm around 2.0 sec 60' time. I'm launching with Sport Trac and Street suspension. Burnout in 2nd gear before taking off.

16GoManGo has had some pretty good 60' times with his setup. Looking to see what everyone else is doing.

Much appreciated in advance.

 

[Unholy707]

2.3 seconds 🥲🙃

 

[motorheadmike]

1.8s

 

[SickToo]

2.0 is fine. Manual trans is for towing and road racing.

Neither require killer 60’

: )

 

[baabootoo]

1.9 to 2.2 when hotter. Are you guys still spinning a lot? I have the 305/45x18 ET Street R's.

 

[HC5120]

Bsouders, what rpm are you launching at?

 

[16GoManGoHC]

I launch just off idle, pushing down on the gas gently while letting the clutch out at the same time. Best track 60’ with MT 315/50-17’s was a 1.39 on super good fresh prep, usually around a 1.5 at the track. I do a 1.9 to 2.1 60’ on the street with 315/30-20 Nitto 555R2’s. You need to get the rear tires flat with the pavement which will need some adjustable suspension pieces out back. I suggest the ADD drag kit which consists of 3 replacement arms for each side and get camber to +.3 to +.5.

Best track run below on slip, the G tech screens are street play on 20 DR’s avg a 2.0 60’, the first Gtech screen with the 1.56 is a track launch on the 17” MT’s. I have not been doing any street 1/4 play since it’s warmed up, my cars been down since May waiting on my axles to return from GForce, they arrived this week so we’ll see soon if I can break into the 10’s on the street at the new power level from this winters pulley changes. Get the rear flattened out and get practicing launches slipping that clutch and throttle control and you’ll be in the 10’s at the track no problem.

 

[Unholy707]

I launch just off idle, pushing down on the gas gently while letting the clutch out at the same time. Best track 60’ with MT 315/50-17’s was a 1.39 on super good fresh prep, usually around a 1.5 at the track. I do a 1.9 to 2.1 60’ on the street with 315/30-20 Nitto 555R2’s. You need to get the rear tires flat with the pavement which will need some adjustable suspension pieces out back. I suggest the ADD drag kit which consists of 3 replacement arms for each side and get camber to +.3 to +.5.

Best track run below on slip, the G tech screens are street play on 20 DR’s avg a 2.0 60’, the first Gtech screen with the 1.56 is a track launch on the 17” MT’s. I have not been doing any street 1/4 play since it’s warmed up, my cars been down since May waiting on my axles to return from GForce, they arrived this week so we’ll see soon if I can break into the 10’s on the street at the new power level from this winters pulley changes. Get the rear flattened out and get practicing launches slipping that clutch and throttle control and you’ll be in the 10’s at the track no problem.

View attachment 599918 View attachment 599919 View attachment 599920 View attachment 599921 View attachment 599922 View attachment 599923 View attachment 599924 View attachment 599925 View attachment 599926 View attachment 599927

That’s one of the best m6 60’ I’ve ever seen! You really got the car dialed in man!!

 

[16GoManGoHC]

That’s one of the best m6 60’ I’ve ever seen! You really got the car dialed in man!!

That was all track prep, I never got into the 1.3x 60’ since But of course I haven’t been taking the cat to the track a lot these last 18 months either. I’ve been doing more roll racing and street playing then track quarter mile running it’s just too hard on parts and the car. O, I did put a Diablo Sport Suspension Controller on in this last year that has helped immensely on the street with traction, Probably were at the track as well. When it cools off this fall I plan on going to the track again with it and see if I can get it in the nines on video this time.

 

[SickToo]

The only way to launch a manual transvehicle consistently is with the throttle pinned, some sort of launch control device like a two-step, and sidestepping some form of a adjustable slipper clutch. Otherwise it is hit and miss and the quick times are far n few in between. Is what it is

 

[Unholy707]

The only way to launch a manual transvehicle consistently is with the throttle pinned, some sort of launch control device like a two-step, and sidestepping some form of a adjustable slipper clutch. Otherwise it is hit and miss and the quick times are far n few in between. Is what it is

I was looking into the stage6 launch controls when I had an m6. Apparently works for the a8 too. The benefits of built in launch control, but without all the Nannys

 

[Unholy707]

That was all track prep, I never got into the 1.3x 60’ since But of course I haven’t been taking the cat to the track a lot these last 18 months either. I’ve been doing more roll racing and street playing then track quarter mile running it’s just too hard on parts and the car. O, I did put a Diablo Sport Suspension Controller on in this last year that has helped immensely on the street with traction, Probably were at the track as well. When it cools off this fall I plan on going to the track again with it and see if I can get it in the nines on video this time.

That’s still awesome. Really, the Diablo suspension controller makes that much difference?

 

[Unholy707]

I launch just off idle, pushing down on the gas gently while letting the clutch out at the same time. Best track 60’ with MT 315/50-17’s was a 1.39 on super good fresh prep, usually around a 1.5 at the track. I do a 1.9 to 2.1 60’ on the street with 315/30-20 Nitto 555R2’s. You need to get the rear tires flat with the pavement which will need some adjustable suspension pieces out back. I suggest the ADD drag kit which consists of 3 replacement arms for each side and get camber to +.3 to +.5.

Best track run below on slip, the G tech screens are street play on 20 DR’s avg a 2.0 60’, the first Gtech screen with the 1.56 is a track launch on the 17” MT’s. I have not been doing any street 1/4 play since it’s warmed up, my cars been down since May waiting on my axles to return from GForce, they arrived this week so we’ll see soon if I can break into the 10’s on the street at the new power level from this winters pulley changes. Get the rear flattened out and get practicing launches slipping that clutch and throttle control and you’ll be in the 10’s at the track no problem.

View attachment 599918 View attachment 599919 View attachment 599920 View attachment 599921 View attachment 599922 View attachment 599923 View attachment 599924 View attachment 599925 View attachment 599926 View attachment 599927

So I was thinking about this, the RedEyes have 0 camber knuckles. Would this be good enough, or would you still get the AAD stuff? My hub bearing sound like they’re going out. Redeye knuckles come with new hubs, $600 for both.

 

[16GoManGoHC]

That’s still awesome. Really, the Diablo suspension controller makes that much difference?

I think yes the DS controller has helped as My street 1/4 times recently posted where cold road launches, I’ve yet to try a hot road street 1/4, maybe this week now that I have it back together. Yesterday morning test run with the new axles, floor it in 3rd gear at 45 it gripped and ripped.

 

[SickToo]

Mine hooks dead up in 3rd too lol

 

[16GoManGoHC]

Mine hooks dead up in 3rd too lol

How much TQ and HP you putting down?

 

[Unholy707]

How much TQ and HP you putting down?

About tree fiddy

 

[SickToo]

🔥 420 💨

Hooks in the water box in 3rd