SRT Hellcat Forum banner
  • Hey Everyone! Vote for the Site Favourite HOTM winner for the year of 2022 HERE!

69 Coronet owners please. Need advice. Electrical.

978 Views 21 Replies 6 Participants Last post by  2ndAmend
4
Turns signal lights but will not flash. Unable to find where to install the replacement flasher. Advice appreciated.
Motor vehicle Car Hood Automotive exterior Electrical wiring
Automotive tire Electrical wiring Cable Gas Fender
Automotive design Automotive lighting Hood Trunk Bumper
Hood Automotive lighting Automotive tire Bumper Vehicle
See less See more
1 - 8 of 22 Posts
Can you find the socket on the harness? Someone took the flasher out? My coronet is 180mi from me atm unfortunately
  • Like
Reactions: 1
In that case, maybe a bad ground finally worn thin? Do they both come on with the off side weaker or only the intended side?
But if you do left signal do only lefts come on and stay on?
2
Font Schematic Engineering Parallel Pattern

Looks like 18g red and black wires into the socket you're looking for

Attachments

See less See more
  • Like
Reactions: 1
probably the flasher then. Those pages are from a 68 service manual but the rallye dash ought to have the same wiring for 69 I'd think.
  • Like
Reactions: 1
bulkhead can cause a lot of trouble but I've never seen it cause a turn signal into a constant light. Of the things going through the bulkhead turn signals are low load, unless there's a short in the circuit somewhere, which would behave differently on it's way to melting the connector.
  • Like
Reactions: 1
1 - 8 of 22 Posts
This is an older thread, you may not receive a response, and could be reviving an old thread. Please consider creating a new thread.
Top