[Deebeezie]

Ok so a little help would be greatly appreciated. Installing the AAD Performance Drag Pak, and nearly finished with the rear. I’m stuck, however, with the inboard bolt in the cradle. Got the nut off fine but I can’t get the bolt to come out to remove the stock toe link. Any ideas or suggestions?

thanks in advance.

 

[GreenMachine15]

Loosen the cradle bolts on one side, pull bolt put new arm in, reinstall bolt, tighten cradle bolts. Then do other side.

 

[Himmelkat]

I figured it was a "loosen the cradle, which is assembled at the factory relatively whole then bolted into place" affair.

 

[Deebeezie]

I got it. Just had to "massage" it out. Overall, pretty easy job. Thanks.

 

[WizzaVTX]

I got it. Just had to "massage" it out. Overall, pretty easy job. Thanks.

Did you use the lockouts provided by AAD on that spot and reverse the bolt?

I think I recall that being the one they recommend reversing.

You see the stock ones on your photo.

 

[xxdirtyjoexx]

I ended up cutting that bolt out when I did it. Thinking loosening and dropping the cradle may have been easier. Those bolts are extremely hard.