No porting required. Non clutched pulley will put put more stress on the snout bearings and over time may need to be replaced. You can pick up up a new set of bearings from Jon Bond Performance for around 100 bucks.
-
Hey Everyone! Vote for the Site Favourite HOTM winner for the year of 2022 HERE!
Blower bearings
Hello all,
If i do a 2.85 do I need to port the blower? I been hearing a lot of stories about bearing failures after pulleys. BTW I have a 2020 Charger HC. Thx!
If i do a 2.85 do I need to port the blower? I been hearing a lot of stories about bearing failures after pulleys. BTW I have a 2020 Charger HC. Thx!
1 - 2 of 11 Posts
Wasn't an option 5 years ago when I modded. Would I go clutched certainly, right now my setup is running fine.Why would anyone NOT go with a clutched pulley?
Also, go with ceramic hybrid bearings if you are going to change them anyway. Better all around bearings.
1 - 2 of 11 Posts
- This is an older thread, you may not receive a response, and could be reviving an old thread. Please consider creating a new thread.
SRT Hellcat Forum
HellCat.org is a forum dedicated to the Dodge Challenger and Charger SRT Hellcat & Demon. Discuss modifications, engine specs, pricing and more!
Full Forum Listing
Recommended Communities
