SRT Hellcat Forum banner
  • Hey Everyone! Vote for the Site Favourite HOTM winner for the year of 2022 HERE!

FAS Billet 2.4 Blower Inlet Plate

1841 Views 9 Replies 4 Participants Last post by  Himmelkat
Brand new in box yet FAS 2.4 Blower Inlet plate. Bolt on a dyno proven 50 HP and broader torque curve. See dyno sheet. This is my M6 Hellcat on 93 with plate installed and before plate was installed, solid 50 HP gain and look how much longer torque holds on for (there’s 2 pulls there, one right over the top of the other, not a fluke) These plates can no longer be purchased for self installation, they are $1000 plus installation and shipping costs. They are not hard to install with the right instructions which I can provide, I’ve successfully installed a few of them, one running on my 2.4 blower currently still. Produces 17.75-18 psi of boost with a 2.85 upper and stock lower pulley. $950 firm plus shipping and any fees, PayPal preferred.
Watch Product Silver Sleeve Analog watch
Helmet Material property Font Silver Fashion accessory
Automotive exterior Bumper Font Handwriting Auto part
Slope Rectangle Font Parallel Pattern
See less See more
  • Like
Reactions: 4
1 - 1 of 10 Posts
Maybe this could be done to the billet plate. Not sure if the factory bearing plate casting could take such a shape and remain structurally sound.
1 - 1 of 10 Posts