[6togo]

I tried all the disconnect tools I have and none seem to allow the disconnect on the fuel rail to pop off anyone have luck with this and what tool did you use? This is the later version rail disconnect not the plastic clip type.

 

[HemiV8]

We had to cut the opening tool a little bit shorter to get in between the rail and the opening of the valve. It was an easy job disconnecting and connecting back together

 

[6togo]

Did you use a plastic tool? What size was it?

 

[HemiV8]

Did you use a plastic tool? What size was it?

It was a set of different sizes in a box purchased over Amazon. It was a friends tool. You have to check which insert fits size wise and then approx. cut a quarter inch off. But only as much as is needed to get the tool in between the spot