SRT Hellcat Forum banner

1 - 4 of 4 Posts

·
Registered
2020 Dodge Challenger Redeye Widebody Hellcat
Joined
·
12 Posts
Discussion Starter · #1 ·
Looking at performing a stainless works mid pipe swap. Curious if I would need to change the O2 sensors in order to avoid throwing a code? If so, what sensor would I need?
 

·
Registered
Challenger SRT Hellcat
Joined
·
1,862 Posts
Your going to get a code.
You can try the big daddies o2 extenders, they fit between your o2 sensors and the pipe.
If your car was tuned, they can be tuned out.
 

·
Registered
2020 Dodge Challenger Redeye Widebody Hellcat
Joined
·
12 Posts
Discussion Starter · #3 ·
Your going to get a code.
You can try the big daddies o2 extenders, they fit between your o2 sensors and the pipe.
If your car was tuned, they can be tuned out.
Thx man. I’m going to have a 10% ATI lower and tune
Your going to get a code.
You can try the big daddies o2 extenders, they fit between your o2 sensors and the pipe.
If your car was tuned, they can be tuned out.
Thank you! I'm going to have a 10% ATI lower and tune. Will I still need the big daddy O2 extenders with the tune?
Thx again
 

·
Registered
Challenger SRT Hellcat
Joined
·
1,862 Posts
No, not with a tune
 
1 - 4 of 4 Posts
Top