It showed P061A. that's all it showed. It has an internal code of U1424-00, C121C-00 and U0401-00 Implausable data from ecu too
-
Hey Everyone! Vote for the Site Favourite HOTM winner for the year of 2022 HERE!
P061 A Level 2 Torque Performance code
Have any of you had this code? From what I've found it is in the pcm. I dont think its in the tune because I have tried a few different tunes and it will go into limp mode on all of them.
It started when I put one of the old tunes back in that it used to run all of the time. Was driving normal and all of a sudden the repair stability control lights came on and then it went into limp mode. always able to shut it off and restart it and it runs fine. It is an HP Tuners unlocked pcm. Also is it possible for a bad pcm to change tune parameters at any time?
Thank you in advance!
It started when I put one of the old tunes back in that it used to run all of the time. Was driving normal and all of a sudden the repair stability control lights came on and then it went into limp mode. always able to shut it off and restart it and it runs fine. It is an HP Tuners unlocked pcm. Also is it possible for a bad pcm to change tune parameters at any time?
Thank you in advance!
1 - 6 of 13 Posts
I just did the calibration and not the full rewrite. Could that cause this?Have you tried rewriting to the ecu ? Is there any values that exceed the factory maximums?
Sent from my BBF100-2 using Tapatalk
Sent from my SM-N975U using Tapatalk
Ok. Thank you. The only thing is it has done the same thing with 3 different tunes.I don't think so . I have never used "full write" and never had an issue . But I have see the write calibration not take some times ( very rare ) .
I would try reloading your tune and try it again
Sent from my BBF100-2 using Tapatalk
Sent from my SM-N975U using Tapatalk
That's what I was wondering. It's a HP tuners unlocked pcm. I have the stock one but I'm not sure what will happen since it has the 2.85 upper and 1050 injectors.Ohhh . That's not good . I wonder if the Pcm got corrupted . It may need to be reflashed by the dealer and you start over .
Sent from my BBF100-2 using Tapatalk
Sent from my SM-N975U using Tapatalk
Ok. That's what I thought. Damn. Lol. Thank you for your help. I wish hp tuners had a phone number to call to see if they can reprogram it or if I need to get a new one. Just sucks at $900 for a new one.You can not start the engine with 1050's and the stock ecu . you would have to put the stock injectors back in if you wanted to try the stock Pcm and no WOT .
Sent from my BBF100-2 using Tapatalk
Sent from my SM-N975U using Tapatalk
1 - 6 of 13 Posts
- This is an older thread, you may not receive a response, and could be reviving an old thread. Please consider creating a new thread.
SRT Hellcat Forum
HellCat.org is a forum dedicated to the Dodge Challenger and Charger SRT Hellcat & Demon. Discuss modifications, engine specs, pricing and more!
Full Forum Listing
Recommended Communities
