SRT Hellcat Forum banner
  • Hey Everyone! Vote for the Site Favourite HOTM winner for the year of 2022 HERE!

Please Help... Dual Fuel Pump Question

4343 Views 14 Replies 4 Participants Last post by  Jonx96
So I just installed my dual fuel pump, and the car fired up. The only problem I see is the 2 blue wires on top of the hat, in all of the pictures I see a factory looking plug on them ( shown below), I have already contacted HHP for an answer but if someone has a quick response as to where I splice the blue wires into (which wire on the factory harness) it would be super grateful.

Thanks in advance all !!!!
575510
See less See more
1 - 6 of 15 Posts
Thanks guys for your input, got it wired up and car runs fine. Only issue with a full tank it’s showing 3/4, I’m going double check the wiring, everything rang out with my tester so kind of in a big question right now... will post results ( maybe it can help someone out )
Mine has been showing slightly below full since my install. I haven't spent anytime yet troubleshooting. I may this weekend. Did you come up with anythng?
Haven’t had the time yet, I’ll post results as soon as I can👍👍
Sounds like the float is hung up on a wire or something and can’t move. You may have to remove the pump assembly and check it
exactly what I’m thinking ..: I will update
UPDATE****

simple as that the float hanger was stuck on one of the pump connectors. I lifted the connection and put it towards the rear of the tank and the float seemed free. Yes I turned the key to accessories to make sure the connections were reading correctly, and just like magic I had more gas than when I parked it. 😂😂😂😂

So hopefully this post will help someone else out there, I know there was a lot of issues out there with this happening.
  • Like
Reactions: 2
Darn this means I have to spend 15 minutes pulling the seat and taking the lock ring off. But hey glad you figured it out. I will be doing the same this weekend I guess.
Where you able to get to it yet?
1 - 6 of 15 Posts
This is an older thread, you may not receive a response, and could be reviving an old thread. Please consider creating a new thread.
Top