SRT Hellcat Forum banner
  • Hey Everyone! Vote for the Site Favourite HOTM winner for the year of 2022 HERE!
1 - 20 of 26 Posts

· Banned
‘16 A8 Shaker
Joined
·
3,116 Posts
Event winner stickers go on the trailer…

Not on the car

Then again - “opinions have caused more troubles on this tiny earth than plagues n earthquakes combined”
 

· HOTY Winner
Challenger SRT Hellcat
Joined
·
3,709 Posts
That is a lot of vinyl for me. I am not into the ebay binge buying for the hellcat.
 

· Registered
Challenger SRT Super Stock
Joined
·
686 Posts
Too much for my liking but I'm a "clean" look with nothing but factory badges/stripes. I may add a old school Wile Coyote to the side window like my pop had on his Roadrunner.. but even that is hard for me.

It's yours.. dress her up as you wish!
 

· Registered
'23 Redeye Jailbreak
Joined
·
4,934 Posts
I think the OP's looks fine. This, taken from a FB Challenger page I belong to... is way too much of everything in my opinion. As I've said before, I believe in the fine line between classy and clown car. Other folks can have their opinions... but I think this is a 3-ring circus kind of car:

FWIW, it was not a WB, not a T/A, not a Redeye. The owner literally went onto the internet and bought one of every mod imaginable and the entire car is a mish-mash of everything. He's in the middle of a many months long stay at the shop to get his engine stroked to a 440 with an R trim ProCharger installed... on top of that air ride (I anticipate bad things). Not to mention how poorly the R trim is on the street (mondo heat issues). Some of the build I like... for example, I like the Samurai graphic. By itself. I don't like it with all the other dozens of stickers that pepper the inside and outside of the car. I like the hood design, by itself. But not with the wicker bills and that godforsaken duraflex looking material the hood is made of. I dislike how the hood is shiny and the roof and side stripes are matte. It's just way too busy for my eyeballs. It would look 2x better if he took half of that stuff off.

Wheel Tire Car Vehicle Sky
 

· Registered
'23 Redeye Jailbreak
Joined
·
4,934 Posts
That thing needs a huge pro stock scoop from 2015 when they ran carbs : )
Supposedly he has a custom made intake to fit the inlet for the ProCharger. It's a high rise deal. So, there's an actual need for that hood. Mixing mediums across a car is just a bad idea. But, whatever, I don't have to drive it... thank God.
 
1 - 20 of 26 Posts
This is an older thread, you may not receive a response, and could be reviving an old thread. Please consider creating a new thread.
Top