SRT Hellcat Forum banner

1 - 8 of 8 Posts

·
Registered
Challenger SRT Hellcat
Joined
·
487 Posts
Discussion Starter #1 (Edited)
SOLD!
This tool is designed to facilitate the removal of the original supercharger pulley on the Hellcat. Once the supercharger snout is off the car and on the bench, this tool slides over the pins at the rear of the snout to hold the supercharger shaft stationary while the pulley is unscrewed at the front. The benefit of this tool is that it spreads the load over all eight pins, which is far better than using a pry bar against two pins. This tool greatly reduces the possibility of any breakage during the pulley removal process. Pin tool is regularly $39.99, and Hex tool is regularly $19.99.

(SOLD) $35 shipped to your door in the U.S. via PayPal or $30 cash local pick up (Arizona) (SOLD)
PM me if you want it. Thanks
 
1 - 8 of 8 Posts
Top