SRT Hellcat Forum banner
  • Hey Everyone! Vote for the Site Favourite HOTM winner for the year of 2022 HERE!

Wiring diagram for Active Damping Suspension Controller?

1105 Views 3 Replies 3 Participants Last post by  b4black
Every time I start the car, I get a "Service Active Dampening System" error message. Scan tool shows a DTC of U0139-00 "lost communication with active damping control module". I tried swapping the controller with another unit, but that didn't fix it. I figure it either lost power or ground, but this thing has 80 wires going to it.

Where can I get a wiring diagram for this so I can check power and grounds first before bringing it to a dealership?

2015 Challenger Hellcat M6

Thanks!
1 - 2 of 4 Posts
Thanks you xcesiv!!!! Very helpful.

A little common sense here. The Power will be quite a bit larger and is Pink or Yellow. Ground is quite a bit larger and is Black. There are 26 wires. Not 80...........
I should have said about 80 pins, not wires. Please, please forgive me if you can. :rolleyes:
  • Like
Reactions: 1
1 - 2 of 4 Posts
This is an older thread, you may not receive a response, and could be reviving an old thread. Please consider creating a new thread.
Top